Fluke CableIQ - Auto Shutoff Settings; Speaker On;Off Control; Resetting to Factory Settings

CableIQ Qualification Tester
Users Manual
14
Auto Shutoff
You can set the tester to stay on indefinitely or turn off
after 15 minutes of inactivity.
To set the auto shutoff:
1 Turn the rotary switch to SETUP.
2 Press
D to highlight Auto Shutoff; then press H or
J.
3 Press
H or J, use A D to select 15 Min or
Never; then press H.
Enabling or Disabling the Speaker
Turning off the speaker does not disable sounds for the
continuity and toner functions.
To turn the speaker on or off:
1 Turn the rotary switch to SETUP.
2 Press
D to highlight Speaker; then press H or
J.
3 Press
H or J, use A D to select On or Off;
then press
H.
Resetting to Factory Settings
The Factory Settings function resets the following to
factory settings:
• NVP settings
• Tests selected for the Autotest
• Wiremap pair selections for Autotests
To reset to factory settings:
1 Turn the rotary switch to SETUP.
2 Press
D to highlight Factory Settings; then press
H or J.
3 Press
JYes.