11. Power on
开机
12. Shut down
1. Connnect all parts
2. Switch on the transmitter
3. Connect the receiver battery
4. The receiver red LED indicator is solid
indicating the presence of a correct signal
5.
6. Use the radio system
When the error rate of transmitter is less than 5%,
the signal of receiver is stable.
1. Cut off power source of receiver
Turn off the transmitter.2.
1. 连接好所有部件
2. 打开发射机
3. 接通接收机电源
4. 接收机红色指示灯常亮说明信号连接正常.
5.发射机的误码率小于5%,接收信号强度稳定(TX/RX电量
充足时)
6. 操作系统可以使用
1. 断开接收机电源
2. 关闭发射机
关机
注：未断开接收机电源，发射机电源是无法关闭的。
Attention: transmitter cannot be turned off if the power
source of receiver is not cut off.
15
Digital propotional radio control system
To Next Page
Loading...
