Maintaining Your Wrist PDA
Calibrating the screen
112
Wrist PDA User Guide
Performing a hard reset
WARNING! Performing a hard reset erases everything on your
watch. All personal data and third-party applications are deleted,
and the watch is returned to its factory default settings.
If possible, back up all personal data before performing a hard reset.
Try resolving your problem first using a soft reset (see above).
To perform a hard reset:
1. While pressing and holding Rocker Enter, press the Reset button
on the side of the watch.
2. When the Palm Powered
TM
logo appears, release Rocker Enter.
3. When prompted, press Page Up to complete the reset, or press any
other button to cancel the operation.
Calibrating the screen
If your Wrist PDA does not accurately detect where you place the
stylus on the screen, you may need to calibrate the screen.
To calibrate your screen:
1. Switch to PDA mode (see page 15).
2. Press Back until you see the Launcher’s All category.
3. Select and open Prefs.
4. Tap the category list in the top-right; then tap Digitizer.
5. Follow the on-screen instructions, tapping the screen where
indicated.
To Next Page
Loading...
