Fostex VM200 - Page 142

Effects
142 VM200 User’s Guide
CHORUS (37)
3D_CHORUS (38)
FLANGE (39)
HI RATIO
0.1–1.0 (0.1 step) High frequency amount of the feedback.
Parameter Value Description
DEPTH
0–100 [%] (1 step) Modulation depth
PRESENCE
-10–0–+10 (1 step)
1
1. Brightness increases with a positive setting, and decreases with a negative setting.
Brightness in the high range of the reverb.
LPF
1.00kHz–20.2kHz, THRU
(step: same as EQ)
Cut-off frequency of the low pass filter.
Parameter Value Description
DEPTH
0–100 [%] (1 step) Modulation depth.
PRESENCE
-10–0–+10 (1 step)
1
1. Brightness increases with a positive setting, and decreases with a negative setting.
Brightness in the high range of the reverb.
LPF
1.00kHz–20.2kHz, THRU
(step: same as EQ)
Cut-off frequency of the low pass filter.
Parameter Value Description
RATE
0.01–2.00 [Hz] (0.01 step) Modulation speed.
DEPTH
0–100 [%] (1 step) Modulation depth.
MOD DLY
0.0–30.0 [ms] (0.1 step)
Delay time from the direct sound until the modu-
lated sound.
FLANGE FB
0–100 [%] (1 step) Feedback amount.
FLA1/2GAIN
0–100 [%] (1 step) Gain of FLANGE 1 or 2.
FLA1/2PAN
L10.00–0.0–R10.0 (0.5
step)
Pan position of FLANGE 1 or 2.
PRESENCE
-10–0–+10 (1 step)
1
Brightness in the high range of the reverberation.
Parameter Value Description