FP PRO PAK'R - 3.4 Cleaning; 3.5 Transport and Storage; 3.6 Commissioning

PRO PAK’R User Manual Version 1.0 Page -22-
FP International
3 operAting instructions
3.5 trAnsport/storAge
3.5.1 generAl
The machine is tted with castors to allow it to be moved rapidly from one workplace to
another. The castors are only suitable for short distances over level, hard factory oors.
3.5.2 storAge
No special instructions apply to storing the machine. A cool and dry area is the most suitable
environment for this purpose.
If the machine has been stored or idle for a length of time, it should be inspected by
maintenance personnel before being taken back into use.
3.6 commissioning
The machine is ready for use ex-factory and does not require any installation. Its rst use,
however, should be monitored by a technician, as should the rst operating session following
a major overhaul or long term storage.
Pay special attention to the following:
• Is there any damage (e.g. incurred during transport),
• Has the machine been set-up correctly (see page 16)
• Does the mains voltage conform to the rating on the identication plate (Page 27)?
• Are all moving parts (feed rollers) free?
Commissioning will generally be carried out by a specialist appointed by the manufacturer or
distributor
3.4 cleAning
Warning!
• During cleaning, the machine must be switched off.
• Electrical components should not come into contact with
water or other liquids.
As a rule, the machine does not need to be cleaned.
If required, the outside may be wiped down using a damp cloth and soapy water.