PRO PAK’R User Manual Version 1.0 Page -5-
FP InternationalFP International
foreword
using the mAnuAl
This user manual details the daily use and maintenance of the PRO PAK’R, an installation that is part
mechanical, part electrical.
Details of maintenance work to be carried out by the manufacturer’s personnel only are expressly
excluded.
This manual is an integral part of the machine and should be carefully looked after! It
contains information that may be useful or required at a later date, for example when
carrying out repairs and maintenance. It is recommended that you keep one copy
near the machine and that you le the other one, for example with the records of your
technical department. The manufacturer may be able to supply you with an additional
copy.
The manual is to accompany the machine, should its ownership be transferred to a third
party.
This PRO PAK’R is provided with a USB key (only FAT formatted USB Stick works)
This manual, also in different languages, is also available on the USB key in the machine.
The instructions in this manual are listed according to the various classes of user of the machine. The
requirements for these different classes of user are given in chapter 2.
In this manual, the terms in the left hand column below are used as dened on the right.
User: The collective designation for everyone working on or with the machine.
Operator: Any person using the machine on a daily basis.
Relevant chapters: Introduction, Safety and Operating Instructions.
Maintenance personnel: Persons with qualications and experience in carrying out the work
described, and disposing of the means required to do so.
Relevant chapters: All
Any work not described in this manual must be carried out by or in consultation with FP International
BV.
The term “product” is used in this manual to refer to the items to be processed by the machine and
therefore does not refer to the machine itself.
The gures included in the text of this manual serve the exclusive purpose of illustration. They are
intended only as text aids, for example to illustrate the location and function of controls or parts.
The actual layout and dimensions may vary. Technical drawings, if required, may be appended or
supplied separately.
To Next Page
Loading...