PRO PAK’R User Manual Version 1.0 Page -7-
FP InternationalFP International
wArrAnty And liAbility
The warranty comprises the following terms and provisions, unless agreed otherwise in
writing:
• The manufacturer enters into this warranty with the original user for 12 months from the date of
delivery of the product.
• Defects must be reported to the manufacturer prior to expiry of the term of warranty.
- The warranty covers defects which:
- occur during normal operation of the machine/assembly;
- arise from defective construction or materials;
- arise from any lack of expertise on the part of the manufacturer;
• The warranty does not cover defects arising from:
- normal wear and tear;
- inexpert or inappropriate use;
- the use of consumables other than prescribed.
• Should any defects occur, the manufacturer will:
- replace the parts. Ownership of the parts replaced reverts to the manufacturer;
- correct the defects;
- opt to replace the equipment should repair, within reason, be ruled out. The customer must
provide the manufacturer with the opportunity to correct any defects;
• Integrated third party components are subject to the warranty of the manufacturer in question. The
applicable term of warranty may vary from the above.
• The manufacturer reserves the right to modify machines/assemblies without prior notice.
Please note that the following limitations apply to the manufacturer’s liability under the
terms of the warranty:
The manufacturer is not liable for potentially dangerous situations, not for incidents or damage
resulting from warnings or instructions supplied either on the machine/assembly or in this manual
having been ignored. No liability applies to, for example:
• inexpert or incorrect use or maintenance;
• use for purposes or under circumstances other than are indicated in this manual;
• the use of parts other than prescribed;
• repairs carried out without the manufacturer’s prior permission;
• modications to the machine/assembly, such as:
- modication of the control system;
- welding, mechanical alterations;
- additions to the machine/assembly or its control system.
Furthermore, the manufacturer is not liable:
• should the customer have failed to full any of his obligations (nancial or otherwise) in respect to
the manufacturer;
• for consequential damage resulting from any failure of or defects to the machine/assembly (such as
damage to products (to be processed), shut-down of operations, delayed production etc.).
To Next Page
Loading...