PRO PAK’R User Manual Version 1.0 Page -19-
FP InternationalFP International
3 operAting instructions
3.3.1 generAl instructions to operAte the mAchine
• Make sure the E-stop is not activated. To deactivate twist the head of the E-stop to release.
• Power the machine on by turning the POWER TOGGLE SWITCH (AC power plug) on the
rear of the machine to ON.
• Press the button on the display panel to activate the machine when prompted on the screen
• Load the film onto the roll holder (Loading film figure 1)
• Open the air channel in the film and pull it over the air fill tube cone (Loading film figure 3)
• Pull the film down into the air tube (Loading film figure 4)
• Press the Forward Button and feed the film down the air tube until the feed rollers grab the
film. (Loading film figure 3)
The Machine is now ready to produce air cushions.
• The RFID technology will read the film installed and set the Pro Pak’r for optimal
performance.
o The fill level, sealing temperature and sealing pressure can be adjusted for specific
applications through the key pad display. (See 3.3.2.)
• The length of string of the air cushions can be set through the key pad display (see 3.3.2.)
o Holding the foot pedal down (if installed) will override the length control setting on the
equipment.
o Tapping the foot pedal will cause the machine to deliver a length of air cushions.
o The machine can be operated with the Start button.
To Next Page
Loading...