Need support? support@freenove.com
Chapter 5 Arduino Software
Programs written with Arduino Software (IDE) are called sketches. These sketches are written in the text editor
and saved with the file extension.ino. The editor has features for cutting/pasting and searching/replacing text.
The message area gives feedback while saving and exporting and also displays errors. The console displays
text output by the Arduino Software (IDE), including complete error messages and other information. The
bottom right-hand corner of the window displays the configured board and serial port. The toolbar buttons
allow you to verify and upload programs, create, open, and save sketches, and open the serial monitor.
Check your code for compile errors .
Compile your code and upload them to the configured board.
Cooperate with Debug tool to debug code.
The data received by the serial port is drawn as a line graph.
Additional commands are found within the five menus: File, Edit, Sketch, Tools, Help. The menus are context
sensitive, which means only those items relevant to the work currently being carried out are available.
To Next Page
Loading...
Need help?
General
