Section 1 Basic Information
1-12
This path allows the water to bypass the dispenser
drawer and enter the tub by the advanced rinsing
technology hose connected between the cavity and the
bellows. (See Figure 1-25)
The detergent dispenser channel receives water from the
right-hand input, as viewed from the front of the washer.
The detergent channel forms a loop that allows the water
to pass over the detergent section of the drawer.
(See Figure 1-26)
Figure 1-25.
Figure 1-26.
Figure 1-27.
As the water pass over the detergent section, holes in
the cavity allows some of the water to enter and fl ush
the detergent cavity. (See Figure 1-27)
Since the fl ow of the incoming water is more than the
holes can dispense, the excess water backs up into a
channel across the rear of the dispenser.
(See Figure 1-28)
Figure 1-28.
Water in this channel and the mixture from the detergent
drawer fl ow into the tub through the large hose at the
rear of the dispenser. (See Figure 1-29)
Figure 1-29.
To Next Page
Loading...
