3.3 Heating up the boiler
3.3.1 Switching on the system
Switch on the main switch on the controls
After the system check by the controls, the system is ready for
operation
3.3.2 Switching on the boiler
All selector switches must be set to “Auto”.
Press the key
The heating system is controlled via the control system according
to the selected mode.
3.3.3 Controlling the boiler
See chapter 4 - Lambdatronic P 3100 control system
3.3.4 Switching off the boiler
Press the key
The boiler follows the shut-down program and switches to
“Burner OFF” status.
The control system then only controls the connected heating
components
3.3.5 Switching off the System
ATTENTION! Only switch off when the boiler has cooled
down.
Switch off the main switch on the controls
The controls are switched off
The system components are powered down.
Caution: The power is still on in the pellet module!
To Next Page
Loading...
Need help?
General