Froling P2-25 User Manual

Installers and service technicians
Initial startup
Fröling Heizkessel- und Behälterbau Ges.m.b.H, Industriestraße 12, A-4710 Grieskirchen, Austria Page 59
Tel +43 (0) 7248 606-0 Fax +43 (0) 7248 606-600 info@froeling.com www.froeling.com B0190806
7
7.4 Initial startup
Initial startup should be carried out with an authorised installer or with Fröling
customer services.
7.4.1 Turn on system
After the boiler has been switched on at the main switch, the controls
carry out a system check and show the standard readout on the display
with mode and operating status.
7.4.2 Changing operating level
The individual parameters are only visible at certain operating levels. To
change to another level it is necessary to enter the relevant user code:
Larger
ENTER
ENTER
Smaller
Child lock
(Code 0)
At “Child lock” level, only the basic readout is
displayed. It is not possible to change
parameters at this level.
Customer
(Code 1)
Standard level in normal operation of controls.
All customer-specific parameters can be
displayed and altered. The parameters available
to the customer are shown in Chapter 4
“Lambdatronic P 3100 console”.
Installer / Service Releases parameters to adjust controls to the
system components. All the parameters shown in
this chapter are available.
 Installer and service level is reset to
customer level after 10 min. of inactivity
(no keys are pressed).
User
Name: Installer
User
Name CUSTOMER
Switched off
Burner Off 
User
Code: 0?
repeatedly

Froling P2-25 Specifications

General

Brand	Froling
Model	P2-25
Category	Boiler
Language	English