Fronius AB Profinet RT - Connecting AB Profinet

Connecting AB
Profinet
NOTE!
While the robot interface is connected to the LocalNet, "2-step mode" automati-
cally remains selected (display: 2-step mode).
Further information on the "Special 2-step mode for robot interface" can be found in the
sections headed "MIG/MAG welding" and "Operating mode parameters" in the power
source Operating Instructions.
Connecting AB Profinet RT
(1)
(2)
1
Connect LocalNet plug on the inter-
connecting hosepack to the LocalNet
connection (1)
2
Connect Profinet data cable to the
Ethernet RJ 45 connection (2)
Connecting AB Profinet IRT
(1)
(2)
(3)
1
Connect LocalNet plug on the inter-
connecting hosepack to the LocalNet
connection (1)
2
Connect Profinet data cable to the
Ethernet RJ 45 connection (2)
3
Use a data cable to connect any other
network devices to the Ethernet RJ 45
connection (2)
59
EN