Flashes red
once
Configuration error
- Too many bus modules / submodules
- I/O of the IO controller configuration too large
- Configuration incorrect (no module, wrong module)
Flashes red
three times
No station name or no IP address assigned
Flashes red four
times
Internal fault
Off Switched off or not initialised
(4) Lights up green Connection to port 2 established
Flashing green Port 2 receiving / transferring data
Off No connection to port 2 or device is switched off
Anybus-S status
indicator
The Anybus-S status indicator is an LED on the surface of the Anybus-S Profi bus
module.
The following errors and statuses are displayed by the Anybus-S status indicator:
Status indicator lights up red
Internal error or operation in "bootloader"
mode
Status indicator flashes red, 1 Hz
Error in RAM configuration memory
Status indicator flashes red, 2 Hz
Error in ASIC or FLASH
Status indicator flashes red, 4 Hz
Error in DPRAM
Status indicator flashes green, 2 Hz
Bus module not initialised
Status indicator flashes green, 1 Hz
Bus module initialised, normal operation
65
EN
To Next Page
Loading...