What to do if my Fronius FlexTrack 45 Welding System shows 'err2'?
If the Fronius Welding System displays 'err2', it indicates a connection problem. You should check all connections and tighten them if necessary. If the control lines are damaged, they should be replaced.
What to do if my Fronius FlexTrack 45 Welding System shows 'err1' error?
If your Fronius Welding System displays 'err1', there might be a short circuit. You should rectify any short circuit found between the lines or communication ports.
Why does my Fronius Welding System show 'err6' and how to fix it?
If the Fronius Welding System displays 'err6', the device needs to cool down. Ensure you operate it in a lower ambient temperature to prevent overheating.
How to fix 'cLs- / cLs+' error on Fronius FlexTrack 45 Welding System?
To resolve the 'cLs- / cLs+' error on your Fronius Welding System, release the limit switch using the traversing direction toggle switch.
What to do for 'oLs- / oLs+' error on Fronius Welding System?
To resolve the 'oLs- / oLs+' error on your Fronius Welding System, release the limit switch using the offset knob.
General| Input Frequency | 50/60 Hz |
|---|---|
| Protection Class | IP23 |
| Cooling Method | Air-cooled |
| Type | Fronius FlexTrack 45 |
| Welding Process | MIG/MAG, TIG |
| Power Source Compatibility | Fronius TransSteel series, Fronius TPS/i series |
| Track Length | 4500 mm |
| Operating Voltage | 24 V DC |
| Power Supply | 24 V DC |
To Next Page
