© FRONIUS 2013 23
14. Magnetic bridges and metrical scale
Magnetic bridges are designed for fixing the guides (rigid, flexible, or orbital) to
ferromagnetic materials. The basic version of the magnetic bridge consists of
an aluminum body, two magnetic blocks with permanent magnets, and levers for
fixing to the surface (when in position ‘1’). Thanks to its modular structure, the bridge
can be easily extended to a version with the fixing mechanism using two M6x20
screws.
The fixing range is 58 mm, while using the distance block further extends the range
by 40 mm.
The maximum holding force of one magnetic bridge is 1500 N.
The fixing mechanism is designed for moving the magnetic/screw feet bridges
radially inside the pipe for mounting or dismounting. Use 5 mm hex wrench to rotate
the M12x3 feed screw which will move the nut along the pins to the distance of 0–58
mm. Fasten the mechanism to the magnetic bridge using two M6x20 screws to
enable adjustment and clamping onto the pipe.
basic magnetic bridge
magnetic bridge
with support
Metrical scale
M6x20
M12x3 feed screw
nut
magnetic bridge with metrical scale
magnetic bridge with
metrical scale and support
M6x20
M6x14
support
To Next Page
Loading...
