© FRONIUS 2013 29
18. Preparing for operation on straight rail
Set power switch in lower position, arc ignition switch to ‘0’
Set travel direction switch in middle position
Set the clutch and the levers of the roller units to OFF
Loosen the M6x20 mounting screws of the rotational roller unit from both sides
and set the rotational rollers in horizontal position.
Remove remote control. The carriage must be mounted on the rail without
remote control!
Mount the carriage on the guide according to the following instructions:
a) Position the carriage on the rail.
b) Hold the carriage using the carrying handle and toggle to ON the lever of the
rotational roller unit and then the lever of the fixed roller unit (proceed in reverse
order when dismounting).
c) By holding the carrying handle, move the carriage along the rail and
simultaneously rotate the engaging lever slowly to ON to position the gear teeth
into the holes of the guide.
Plug the cables of the controller, drive system, oscillator, and welding device
into the proper sockets.
Mount the torch in holder and secure with the knob
Put the torch cable into the cable holder, secure with the knobs, and fix the
holder in a required position.
To Next Page
Loading...
