1
Turn off the automatic circuit breaker.
Set the DC disconnector to the "Off"
switch position.
2
Loosen the 5 screws of the connection
area cover by rotating them 180° to
the left using a screwdriver (TX20).
Remove the connection area cover
from the device.
3
Press the lock on the back of the ter-
minal and remove the AC terminal.
Guide the mains cable from below
through the cable gland on the right
side.
IMPORTANT!
The ground conductor must be dimen-
sioned longer and laid with a move-
ment loop so that it strained last in the
event of a failure of the cable gland.
For more information on the cable
gland, see chapter Cable diameter of
the AC cable on page69.
72
To Next Page
Loading...
