General
General require-
ments
NOTE!
The ROB I/O fieldbus extend module is supported only by a bus control with a
software version 1.00.16 or higher. Older software versions will need to be up-
dated.
Machine concept The ROB I/O is designed to be installed in a control cubicle, although it can also
be mounted in practically any desired position.
Advantages:
-
Linked up to field-bus control via standardised LocalNet interface
-
No need for any modifications to the field-bus control
-
Field-bus control can easily be changed
-
Simple plug-in connections
-
Limited amount of wiring and cabling needed
-
High degree of interference immunity during data transmission
-
Can be mounted using top-hat rail holder
NOTE!
The LocalNet passive distributor cannot be used together with a TIG JobMaster
welding torch.
22
To Next Page
Loading...
