Fronius Robacta TC 2000 - Bolting the Cleaning Device to the Underlying Surface (Foundation); Screwing the Cleaning Device and Installation Stand to the Underlying Surface (Foundation)

43
EN
Bolting the cleaning device to the underlying sur-
face (foundation)
Screwing the
cleaning device
and installation
stand to the un-
derlying surface
(foundation)
NOTE!
The device should only ever be set up with the designated installation stand.
NOTE!
Different fixings may be required to connect the installation stand to the underlying
surface (foundation) depending on the nature of this surface.
The fixings required to connect the installation stand to the underlying surface (foundation)
are not included in the scope of supply of the installation stand. The screws included in the
scope of supply of the installation stand are not suitable for fixing the installation stand to
the underlying surface. The installer is responsible for selecting the right type of fixing.
Place the optional installation stand on a level, firm and vibration-free surface (foun-
dation)
- Position the installation stand in such a way that the distance the robot has to trav-
el to the cleaning device on the installation stand is as short as possible
Screw the installation stand to the underlying surface (foundation) using the appropri-
ate fixings
Position the cleaning device on the in-
stallation stand
Screw the cleaning device to the instal-
lation stand using the four screws sup-
plied with the cleaning device
1
2
3
4