49
EN
Filling the dipping bowl with parting agent
Filling the dipping
bowl with parting
agent
NOTE!
Only use the "Robacta TC Cool +" parting agent supplied by the manufacturer.
The composition of the manufacturer's parting agent is intended specifically for the Robac-
ta TC. If other manufacturers' products are used, trouble-free operation cannot be guaran-
teed.
Fold out the container holder containing the empty "Robacta TC Cool +" parting agent
container
Remove the empty "Robacta TC Cool +" parting agent container and dispose of it ac-
cording to national regulations
Open a new "Robacta TC Cool +" parting agent container and put it into the holder
Fold the container holder containing the full "Robacta TC Cool +" parting agent con-
tainer carefully back above the dipping bowl
- The optimum fill-level is regulated automatically
NOTE!
Carry out the following maintenance on the dipping bowl at weekly intervals:
► Take the spill tray out of the dipping bowl and dispose of any accumulated dirt
► Check the consistency of the "Robacta TC Cool +" parting agent. If the "Robacta TC
Cool +" parting agent is thick, add fresh water and stir to mix in
► Check the level sensor in the dipping bowl for dirt and clean if necessary
NOTE!
Carry out the following maintenance on the dipping bowl every three months:
► Drain all the parting agent from the dipping bowl
► Take the spill tray out of the dipping bowl and dispose of any accumulated dirt
► Clean the dipping bowl and spill tray
► Fill the dipping bowl with new parting agent
Take care never to damage the level sensor when performing maintenance work.
1
2
3
3 421
To Next Page
Loading...
