68
Care, maintenance and disposal
Before each start-
up
- Check the fill level in the "Robacta Reamer" parting agent container and the dipping
bowl, top up if necessary
NOTE!
The "Robacta TC Cool / Robacta TC Cool MD" and "Robacta Reamer" parting agents
differ in their composition.
Use the appropriate medium depending on the application concerned.
Daily
NOTE!
Only use solvent-free cleaning products on the devices.
Remove any deposits of parting agent or contaminants from the outside of the base
and cleaning units.
Weekly - Empty the spatter tray for welding residues
- Take the spill tray out of the dipping bowl and dispose of any accumulated dirt
- Check the consistency of the "Robacta TC Cool / Robacta TC Cool MD" parting agent.
If the "Robacta TC Cool / Robacta TC Cool MD" parting agent is viscous, add fresh
water and stir to mix with the parting agent
- Check the level sensor in the dipping bowl for dirt and clean if necessary
- Clean the cleaning opening on the inside
- Check the "Robacta Reamer" and "Robacta TC Cool / Robacta TC Cool MD" parting
agent containers for soiling and clean if necessary
- Blow compressed air through the suction filter in the "Robacta Reamer" parting agent
container from the inside outwards using the suction hose (see "Connecting the clean-
ing device to the "Robacta Reamer" parting agent container")
- Check the condition of the brush seal above the cleaning opening. Replace the brush
seal if worn (not applicable for twin devices)
Every 3 months
NOTE!
Take care never to damage the level sensor when performing maintenance work.
Robacta TC 1000:
Drain all the parting agent from the dipping bowl
Take the spill tray out of the dipping bowl and dispose of any accumulated dirt
Clean the dipping bowl and spill tray
Fill the dipping bowl with new parting agent
1
2
3
To Next Page
Loading...
