51
EN
Starting up the cleaning device
General
NOTE!
Not coating the interior of the welding torch may result in permanent soiling of the
torch when welding begins.
Always wet the inside of the welding torch with the manufacturer's "Robacta Reamer" part-
ing agent before starting automatic operation.
To achieve the best cleaning results, please note the following:
- Apply an even layer of parting agent to the inside of the torch
- Follow the cleaning sequences as described below
- Keep to the specified cleaning positions
- Blow out the welding torch with compressed air during the cleaning operation (howev-
er not when parting agent is being actively sprayed into the torch interior)
NOTE!
Single, small bits of welding spatter cannot be removed by the cleaning device.
However, these small pieces do not influence the welding process.
Prerequisites for
start-up
The following requirements must be met before the cleaning device is started up:
- Cleaning device is bolted to underlying surface
- If present, connect the "Robacta Reamer" parting agent container to the cleaning de-
vice
- If using the dipping bowl, the dipping bowl is filled with the "Robacta TC Cool +" parting
agent
- If present, wire cutter installed and supplied with compressed air
- Cleaning device connected to mains
- If the cleaning device has been connected to the "Robacta Reamer" parting agent
container: compressed air supply to cleaning device has been established
- Cleaning device connected to robot control
Gas nozzle to
spool body dis-
tance control
When the welding torch is in the spool (correct insertion depth), the torch must be free to
move in every direction.
To check whether the torch has sufficient freedom of movement, it must have to be firmly
pressed by hand in 4 directions before it will touch the spool wall.
To Next Page
Loading...
