53
EN
Cleaning the gas
nozzle tip and
nozzle fitting - de-
tailed description
NOTE!
During the cleaning operation, blow out the welding torch with compressed air
through the hosepack - any remaining dirt or parting agent is removed.
NOTE!
Ensure that the gas nozzle does not
touch the housing components of the
cleaning opening at any time.
Position the welding torch approxima-
tely 50 mm (1.97 in.) centrally above
the middle of the cleaning opening
NOTE!
If the brush seal (1) is fitted, note the
changed reference point when positio-
ning the welding torch.
Move the welding torch vertically into the cleaning position
- see figure
Begin cleaning and hold the welding torch for approximately 1 second in the cleaning
position
Spraying parting
agent - detailed
description
Applying parting agent evenly has the following advantages:
- reduced welding spatter accumulation
- prevents re-soiling
NOTE!
If the brush seal (1) is fitted, note the changed reference point when positioning the
welding torch.
NOTE!
Ensure that the gas nozzle does not touch the housing components of the cleaning
opening at any time.
60 mm
( 2.36 in.)
50 mm
( 1.97 in.)
(1)
3
To Next Page
Loading...
