54
Place the welding torch in the spray
position
- see figure
NOTE!
During the spraying process, ensure
that compressed air is not blown out
through the welding torch.
Spray welding torch with parting agent
for approximately 0.7 seconds
Move the welding torch to the start position above the cleaning opening - approximate-
ly 50 mm (1.97 in.) centrally above the middle of the cleaning opening
- The cleaning operation is complete and the welding torch is ready for use again
Ensure that not too much parting agent has accumulated on the gas nozzle (no droplet
formation). If this is the case :
- Reduce the spray time or
- After the cleaning operation, blow out the welding torch with compressed air using
the hosepack
75 mm
( 2.95 in.)
65 mm
( 2.56 in.)
(1)
3
4
To Next Page
Loading...
