67
EN
Error is sent to the robot. Overtemperature and fill level indicators flash at the same
time, no cleaning takes place
Cause: Quick Stop is active (HI - Quick Stop = LO / LO - Quick Stop =HI)
Remedy: Deactivate Quick Stop (HI - Quick Stop = HI / LO - Quick Stop =LO)
Cause: Fault in the cleaning device
Remedy: Disconnect the cleaning device from the mains and wait for approx. 1 minute
before reconnecting it to the mains
Contact After-Sales Service if this does not remedy the situation
To Next Page
Loading...
