10
Safety inspection The manufacturer recommends that a safety inspection of the device is performed at least
once every 12 months.
A safety inspection should be carried out by a qualified electrician
- after any changes are made,
- after any additional parts are installed, or after any conversions,
- after repair, care and maintenance has been carried out,
- at least every 12 months.
For safety inspections, follow the appropriate national and international standards and di-
rectives.
Further details on safety inspections can be obtained from your service centre. They will
provide you, on request, with any documents you may require.
Markings on the
device
Devices with the CE marking satisfy the essential requirements of the applicable guide-
lines.
Devices displaying the EAC mark of conformity satisfy the requirements of the relevant
standards in Russia, Belarus, Kazakhstan, Armenia and Kyrgyzstan.
Disposal Do not dispose of the product in domestic waste. Dispose of it according to the disposal
requirements for waste electrical and electronic equipment valid at the installation site.
Copyright Copyright of these operating instructions remains with the manufacturer.
The text and illustrations are all technically correct at the time of printing. We reserve the
right to make changes. The contents of the operating instructions shall not provide the ba-
sis for any claims whatsoever on the part of the purchaser. If you have any suggestions for
improvement, or can point out any mistakes that you have found in the instructions, we will
be most grateful for your comments.
To Next Page
Loading...
Need help?
General
