48
Reset Factory Settings:
- Resets to factory settings.
Reset Default Settings:
- Resets settings to the manufacturer's
defaults.
USB mode
In USB mode, the display shows whether or
not a USB flash drive is connected.
The USB flash drive must conform to the
following specifications:
- Formatting: FAT32
- 32 Gigabyte maximum
- Non multi-partitioned
The I-SPoT VIEWER
software supports the visualisation and evaluation of data on the
USB flash drive.
Only insert the USB flash drive when charging is not in progress or if the charging process
has been interrupted.
If the charging process is only interrupted, not completed, it is only possible to read out da-
ta. A new update or configuration cannot be loaded.
Use the "Pause/Start" key to access the following settings.
Use the "Up/Down" keys to scroll between the settings.
Use the "Pause/Start" key to confirm the desired setting.
A USB flash drive may be connected while charging is in progress, after the "Pause/Start"
key has been pressed. However, this can only be used to read out data. An update or new
configuration cannot be loaded.
Safely remove
- Safely remove the USB flash drive as soon as the desired action has been completed.
Update
- A list of the suitable update files stored on the USB flash drive opens.
- Select and confirm the desired file in the same way as scrolling through the settings.
- Do not change the automatically assigned file names of the update file!
- The latest firmware is available in the Download area
of the Fronius website.
- The firmware installation instructions are included in the download’s zip file.
2
3
To Next Page
Loading...
Need help?
General
