38
The individual selection options are explained in greater detail below.
Electrolyte circu-
lation
"Air Pump" electrolyte circulation (not avai-
lable on the Selectiva 220 V variant):
The electrolyte circulation cycle is control-
led by the charger's control system. A num-
ber of selection options are available for
this purpose.
The following settings are available for electrolyte circulation:
Off
- Electrolyte circulation switched off.
Continuous operation (“continuous”)
- Electrolyte circulation permanently on.
Program 1 to 5
- Default electrolyte circulation programs and their relevant parameters can be found in
the table under "Settings" in the "Display" chapter.
Automatic
- Automatic adjustment of the electrolyte circulation flow rate based on the set battery
parameters.
User - “On”/”Off”
- Individual setting of the electrolyte circulation.
- The settings for "On" and "Off" determine the pulse/pause ratio of the air flow intervals.
Default electrolyte circulation programs and their relevant parameters can be found in the
table below:
In each of these programs, the solenoid valve opens for a time "ON 1" and closes for a time
"OFF 1". This process is repeated for the number of times specified under "Repeat". After
this number of repetitions has been completed, the process continues with the "ON 2" and
"OFF 2" times until charging is completed.
Program ON 1 OFF 1 Repeat ON 2 OFF 2
1 30 min 25 min 1 x 5 min 25 min
2 3 min 10 min 4 x 3 min 20 min
3 3 min 12 min 1 x 3 min 12 min
4 5 min 10 min 3 x 5 min 20 min
5 2,5 min 7,5 min 1 x 2,5 min 7,5 min
To Next Page
Loading...
Need help?
General
