51
EN
(52) Battery data cannot be requested
(53) Battery voltage not supported
(54) Communication fault
(55) Battery fault
(56) Battery does not switch on
(57) Message time limit exceeded
(58) Registration failed
Status codes in the event of a charging error
No. Cause
(31) Timeout in I1 phase
(32) Timeout in U1 phase
(33) Battery overvoltage in the I2 phase
(34) Ah limit exceed
(35) Timeout in I2 phase
(36) Target voltage in I2 phase not reached (with format characteristic only)
(37) Problem with RI charge
(38) Set charging time cannot be reached
(39) Timeout in RI charge
Status codes in the event of a fault in the primary circuit
No. Cause
(500) Module 1 (top) temperature sensor faulty
(501) Module 2 (bottom) temperature sensor faulty
(502) PCB temperature sensor faulty
(503) Primary overtemperature
(504) Fan blocked/faulty
(505) Intermediate circuit over/undervoltage
(506) Intermediate circuit imbalance
(507) Primary supply voltage outside the tolerance
(508) Grid failure
(509) Wrong device configuration
(510) Primary EEPROM faulty
(527) Phase shifter overcurrent
To Next Page
Loading...
Need help?
General
