40
Reset settings The menu item below "General options" offers two alternative ways of resetting all the set-
tings:
Reset Factory Settings:
- Resets to factory settings
Reset Default Settings:
- Resets settings to the manufacturer's
defaults
USB mode
In USB mode, the display shows whether or
not a USB flash drive is connected.
The USB flash drive must conform to the
following specifications:
- Formatting: FAT32
- 32 Gigabyte maximum
- Non multi-partitioned
The I-SPoT VIEWER software supports the visualisation and evaluation of data on the
USB flash drive. The I-SPoT VIEWER software can be found online at the following ad-
dress: http://www.fronius.com/i-spot.
Only insert the USB flash drive when charging is not in progress or if the charging process
has been interrupted.
If the charging process is only interrupted, not completed, it is only possible to read out da-
ta. A new update or configuration cannot be loaded.
A USB flash drive may be connected while charging is in progress, after the "Stop/Start"
key has been pressed. However, this can only be to read out data. An update or new con-
figuration cannot be loaded.
Use the "Stop/Start" key to access the following settings
Use the "Up/Down" keys to scroll between the settings
Use the "Stop/Start" key to confirm the desired setting
1
2
3
To Next Page
Loading...
