Fronius Selectiva 4185 - Charging the Battery; Charging

25
EN
Charging the battery
Charging
WARNING!
Danger due to improper handling of the lithium battery.
This may result in serious injury and damage to property.
► Note the following points without exception:
► Only connect lithium batteries that have been approved by the manufacturer to the
charger.
► Never expose the lithium battery to naked flames. Excessive heat can cause the bat-
tery to ignite or explode.
► If the lithium battery becomes damaged due to improper handling, poisonous sub-
stances can escape which are harmful to health.
► Do not drop the lithium battery into water. This may lead to a short circuit. This in turn
can cause the battery to become hot, ignite or explode.
► Do not charge batteries with visible damage.
WARNING!
Danger due to a faulty battery.
This may result in serious injury and damage to property.
► Before charging, ensure that the battery is in full working order.
NOTE!
Danger due to very dirty charging plug contacts.
This can result in damage to property.
► The resulting increase in contact resistance can lead to overheating and subsequent
destruction of the charging plug.
► Keep the charging plug contacts free from impurities and clean them if necessary.
Connect the charger mains plug to the electrical mains supply
The display appears in standard mode. The display shows the charger parameters:
- Type of battery (Li-Ion)
- Charging characteristic, e.g. Fronius Li-Ion
- Charger voltage range, alternates with the maximum output current, or only the battery
nominal voltage if a battery is connected
- Connection status:
Not connected, or
Connected
- Day of the week, date and time
The charger parameters can be set individually. More information on the charger parame-
ters can be found under "Configuration mode" in the "Display functions" chapter. Ensure
that the battery to be charged matches the configuration of the battery charging system.
1