Fronius Selectiva Series User Manual

50
(26) Cell fault detected
(27) Battery not supported
(28) Battery heavily discharged - safety charging is being carried out
(29) Battery is connected with reverse polarity
(30) Thermal runaway
(100) - (400) General battery fault
Status codes in the event of a CAN fault
No. Cause
(51) Battery not responding
(52) Battery data cannot be requested
(53) Battery voltage not supported
(54) Communication fault
(55) Battery fault
(56) Battery does not switch on
(57) Message time limit exceeded
(58) Registration failed
Status codes in the event of a charging error
No. Cause
(31) Timeout in I1 phase
(32) Timeout in U1 phase
(33) Battery overvoltage in the I2 phase
(34) Ah limit exceed
(35) Timeout in I2 phase
(36) Target voltage in I2 phase not reached (with format characteristic only)
(37) Problem with RI charge
(38) Set charging time cannot be reached
(39) Timeout in RI charge
Status codes in the event of a fault in the primary circuit
No. Cause
(500) Module 1 (top) temperature sensor faulty

Fronius Selectiva Series Specifications

General

Device Category	Battery Charger
Manufacturer	Fronius
Series	Selectiva
Microprocessor Controlled	Yes
Battery Types	Lead-acid, AGM, Gel
Protection Class	IP20
Protection Features	Reverse polarity, short circuit, overvoltage, overtemperature
Dimensions	Varies by model
Weight	Varies by model
Output Voltage	12/24 V DC