47
EN
- Time interval (s) for recording charging
parameters on the USB stick (USB
Logging Time)
- Reset statistics
- Reset history
For more detailed information on the statistics and history, please refer to the "Statistics
mode" and "History mode" sections.
Reset settings The menu item below "General options" offers two alternative ways of resetting all the set-
tings:
Reset Factory Settings:
- Resets to factory settings.
Reset Default Settings:
- Resets settings to the manufacturer's
defaults.
USB mode
In USB mode, the display shows whether or
not a USB flash drive is connected.
The USB flash drive must conform to the
following specifications:
- Formatting: FAT32
- 32 Gigabyte maximum
- Non multi-partitioned
The I-SPoT VIEWER
software supports the visualisation and evaluation of data on the
USB flash drive.
Only insert the USB flash drive when charging is not in progress or if the charging process
has been interrupted.
If the charging process is only interrupted, not completed, it is only possible to read out da-
ta. A new update or configuration cannot be loaded.
Use the "Pause/Start" key to access the following settings.
Use the "Up/Down" keys to scroll between the settings.
Use the "Pause/Start" key to confirm the desired setting.
A USB flash drive may be connected while charging is in progress, after the "Pause/Start"
key has been pressed. However, this can only be used to read out data. An update or new
configuration cannot be loaded.
2
3
To Next Page
Loading...
Need help?
General
