Fronius Selectiva Series - Power Path Status Codes

52
(570) Secondary relay cannot be switched
(571) ADC/SPI error
Status codes in the event of a fault in the controller
No. Cause
(540) Configuration memory chip missing/faulty
(541) No secondary communication
(542) Secondary initialisation failed
(543) Program/memory fault in characteristic control
(544) Program/memory fault in characteristic control
(545) Primary initialisation failed
(546) Update failed
(547) Load/save settings failed
(548) Load/save characteristic settings failed
(549) Charging could not be resumed after a power failure
(550) Time not set
(551) Hardware change detected
(552) Configuration memory chip invalid
(553) Primary update failed
(554) Fault in the master-slave communication
(555) Incorrect device software
Power path status
codes
The status code indicates which power path is affected:
- (1): Power path 1 - e.g. Statecode (542-1)
- (2): Power path 2 - e.g. Statecode (542-2)