Fronius TransPuls Synergic 5000 User Manual

MIG/MAG welding
Safety
WARNING!
Danger from incorrect operation.
Possible serious injury and damage to property.
▶
Do not use the functions described here until you have read and completely under-
stood these Operating Instructions.
▶
Do not use the functions described here until you have fully read and understood all
of the Operating Instructions for the system components, in particular the safety
rules!
WARNING!
An electric shock can be fatal.
If the power source is connected to the mains electricity supply during installation, there
is a high risk of very serious injury and damage.
▶
Before carrying out any work on the device make sure that the power source mains
switch is in the "O" position
▶
Before carrying out any work on the device make sure that the power source is
unplugged from the mains
General tasks
before MIG/MAG
welding
1
Only where a cooling unit and water-cooled welding torch are used:
- TPS 2700 with water cooling:
Plug the water hoses of the welding torch to the correct connection sockets on
the cooling unit
- TS 4000 / 5000, TPS 3200 / 4000 / 5000 with water cooling:
Connect the water hoses of the welding torch to the correct connection sockets
on the wire-feed unit
2
Plug in the mains plug
3
Move the mains switch to the "I" position:
- all the indicators on the control panel light up briefly
- where applicable, the cooling unit starts to run
NOTE!
Follow the safety rules and note the operating conditions in the cooling unit
operating instructions.
Overview MIG/MAG welding is composed of the following sections:
- MIG/MAG synergic welding
- MIG/MAG standard manual welding
- CMT welding
- Special functions and options
- Robot welding
100
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044

Fronius TransPuls Synergic 5000 Specifications

General

Brand	Fronius
Model	TransPuls Synergic 5000
Category	AC Power Distribution
Language	English