Dynamic correction
for influencing the short-circuiting dynamic at the instant of droplet transfer
0 harder, more stable arc
10 soft, low-spatter arc
Gas pre-flow time
Gas post-flow time
Feeder creep speed
The settings for the background parameters gas pre-flow time, gas post-flow time and
feeder creep speed are described in the Setup menu.
Adjusting para-
meters for cor-
rection
1
Press the Parameter selection button to select the parameter you wish to correct
2
Use the adjusting dial to set the selected parameter to the desired value. The para-
meter value is displayed in the digital display located above it.
106
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044
To Next Page
Loading...
Need help?
General
