4
Press and hold the Store button
NOTE!
If the selected program location already has a job stored in it, then this exist-
ing job will be overwritten with the new job.
This action cannot be undone.
The left-hand digital display reads "Pro" - the job is copied to the program location
you have just selected.
"PrG" appears on the left-hand digital display to indicate that the job has been
copied.
5
Release the Store button.
6
Briefly press the Store button to exit from the Job menu
The power source switches to the setting selected before the job was copied.
Deleting a job
NOTE!
Jobs are deleted in the Job menu, not in the job mode process.
Stored jobs can also be deleted again. To delete a job, proceed as follows:
1
Briefly press the Store button to change to the job menu
The first vacant program location is shown.
2
Using the adjusting dial, select the job to be deleted (the DEL symbol lights up on
the wire diameter button).
129
EN
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044
To Next Page
Loading...
Need help?
General
