Standard control panel
General
NOTE!
On the Standard control panel, only the MIG/MAG standard synergic welding pro-
cess is available.
The following processes and functions are not available and cannot be retrofitted:
▶
MIG/MAG pulse synergic welding
▶
Job mode
▶
TIG welding
▶
Manual metal arc welding
▶
Spot welding
Any changes to the “Welding current” and “Arc-length correction” parameters have to be
made on the wire-feed unit.
Standard control
panel
(3) (5)
(15)(14)
(6) (9) (10)(8)(7)(4)
(13)
(12) (11)
(2)(1)
(16)
34
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044
To Next Page
Loading...