EasyManuals Logo

Fronius TransPuls Synergic 5000 User Manual

Fronius TransPuls Synergic 5000
212 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #167 background imageLoading...
Page #167 background image
Service codes for push-pull calibration
Safety
WARNING!
An electric shock can be fatal.
Before opening the device
â–¶
Turn the mains switch to the "O" position
â–¶
Unplug the device from the mains
â–¶
Ensure the device cannot be switched back on
â–¶
Using a suitable measuring instrument, check to make sure that electrically charged
components (e.g. capacitors) have been discharged
Service codes
when the drive
units are disen-
gaged ("open-cir-
cuit" calibration)
Err | Eto
Incorrect measurement during push-pull calibration
Repeat push-pull calibration
Cause:
Remedy:
St1 | E 1
At minimum wire feed speed, the wire-feed unit motor does not deliver any
actual rotational speed value.
Repeat the push-pull calibration. If the error message re-appears: Contact
After-Sales Service.
Cause:
Remedy:
St1 | E 2
At maximum wire feed speed, the wire-feed motor does not deliver any
actual rotational speed value.
Repeat the push-pull calibration. If the error message re-appears: Contact
After-Sales Service.
Cause:
Remedy:
St1 | E 3
At minimum wire feed speed, the wire-feed unit motor does not deliver any
actual rotational speed value.
Repeat the push-pull calibration. If the error message re-appears: Contact
After-Sales Service.
Cause:
Remedy:
St1 | E 4
At minimum wire feed speed, the wire-feed unit motor does not deliver any
actual rotational speed value.
Repeat the push-pull calibration. If the error message re-appears: Contact
After-Sales Service.
Cause:
Remedy:
St1 | E 5
At maximum wire feed speed, the wire-feed motor does not deliver any
actual rotational speed value.
Repeat the push-pull calibration. If the error message re-appears: Contact
After-Sales Service.
Cause:
Remedy:
St1 | E 6
At maximum wire feed speed, the wire-feed motor does not deliver any
actual rotational speed value.
Repeat the push-pull calibration. If the error message re-appears: Contact
After-Sales Service.
Cause:
Remedy:
167
EN
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044

Table of Contents

Other manuals for Fronius TransPuls Synergic 5000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fronius TransPuls Synergic 5000 and is the answer not in the manual?

Fronius TransPuls Synergic 5000 Specifications

General IconGeneral
BrandFronius
ModelTransPuls Synergic 5000
CategoryAC Power Distribution
LanguageEnglish

Related product manuals