EasyManuals Logo

Fronius TransPuls Synergic 5000 User Manual

Fronius TransPuls Synergic 5000
212 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #166 background imageLoading...
Page #166 background image
8
Press the “Feeder inching” button or the torch trigger
The wire-feed unit motors are calibrated while under load. During the calibration pro-
cess "run" is displayed on the right-hand digital display.
If the push-pull unit does not need to be calibrated while under load (St2), the previ-
ously set values (e.g. "PPU" and "5") will appear on the digital display when you
press the Feeder inching button or torch trigger.
Calibration of the push-pull unit is complete when the previously set values - e.g.
"PPU" and "5" - reappear on the digital display.
9
Press the Store button twice to exit from the set-up menu
166
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044

Table of Contents

Other manuals for Fronius TransPuls Synergic 5000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fronius TransPuls Synergic 5000 and is the answer not in the manual?

Fronius TransPuls Synergic 5000 Specifications

General IconGeneral
BrandFronius
ModelTransPuls Synergic 5000
CategoryAC Power Distribution
LanguageEnglish

Related product manuals