4-4
Ver.1.36
4.2 BEFORE STARTING AN ANALYSIS
Before starting an analysis the system configuration (e.g., Selective Sampler, MicroJet Cryo-Trap,
etc.) must be entered into the system. Set the interface temperature and its control mode according
to the procedure described below.
4.2.1 System Configuration
4.2.1.1 Selecting a device or devices
(1) Click on “Settings” button (F. in Fig. 4.3) will display the screen shown in Fig. 4.4.
(2) “Check” the small checkbox to indicate that the device will be used.
(3) If air is used as an atmosphere gas, refer to section 4.2.1.3 of this manual.
(4) Click “OK” to end.
4.2.1.2 Abbreviations for accessory devices
CGS: Carrier Gas Selector
SS: Selective Sampler
MJT: MicroJet Cryo-Trap
AS: Auto-Shot Sampler
Fig. 4.4 System configuration
To Next Page
Loading...