FRYER CM Series - General Information and Maintenance; Maintenance Schedule Chart

11
3.0 GENERAL INFORMATION
3.1 MAINTENANCE SCHEDULE CHART
*FOR FURTHER MAINTENANCE DETAIL, REFER TO THE MACHINE COMPONENT SECTIONS IN THE MANUAL
LISTED BELOW.
CAUTION! Always follow all Lock Out / Tag Out procedures before performing any maintenance
MAINTENANCE ITEM
RECOMMENDED
Daily
Weekly
6 Mo
As
Required
Check air pressure gage
90 – 125 PSI
X
At the end of the day remove and
dispose of chips
Use of brush or vacuum is
recommended. Do not use air as it
can push chips into waycovers and
ballscrews.
X
Check axis lubrication pump oil level
See Section 3.201 – Use Mobil Vactra
#2 (ISO 68) or equivalent
X
Clean chips from interior of ATC
See Section 3.204 for details
X
Check pneumatic (air) lubrication oil
Add Mobil ALMO break free synthetic
air tool oil (5W-10W)
X
Check coolant level
Complete a visual inspection
X
Check machine level
See Section 2.61 for details
X
Check axis backlash
See procedure in Section 3.43
X
Remove and clean underside of
waycovers / check sliders and
bumpers for wear and/or damage
See Section 3.44 for details
X
Check wipers for adjustment / damage
See Section 3.44 for details
X
Check ballscrew endplay
See procedure in Section 3.45
X
Check axis motor belts
See procedure in Section 3.46
X
Grease ATC cam pockets
See Section 3.24 for details
X
Change coolant
Blasocut BC40 NF-PL or equivalent
X
Check and change electrical cabinet
air filters
Use Purolator A23465 air filters
X
Change ATC gearbox oil
Mobilgear 600XP 150, Shell
Omala EP 150-220 or equivalent
Yearly
Chiller fluid
Oil Chiller: VG-32 Oil
Yearly