5
10. Never clean up chips while the machine is running or is in automatic mode.
11. Do not file workpieces being rotated under power.
12. At the end of the workday the machine should be placed in "EMERGENCY STOP MODE"
13. When restarting a machine after it has been shut down always assume it has been altered. Recheck all phases of
the job as though you were running the first piece.
14. Never run the spindle until hands, feet, and body are well clear of the work area.
1.02 Electrical Safety
1. WARNING: Electrical enclosures contain high voltage. Disconnect equipment from power source before opening
cabinets.
2. Before replacing a fuse, switch off the machine.
3. Immediately turn off power if:
• Power problems develop
• In the event of electrical storms.
• Ambient temperatures exceed 105 degrees Fahrenheit (40 degrees C)
4. The electrical power must meet the specifications in this manual. Attempting to run the machine from any other
source can cause severe damage and will void the warranty.
5. The electrical panel should always be closed and locked except during service.
6. When the main circuit breaker is on, there is high voltage throughout the electrical panel and some components
operate at high temperatures, therefore extreme caution is required.
7. Do not reset a circuit breaker until the reason for the fault is investigated.
8. Never service the machine with the power connected.
To Next Page
Loading...