FRYER CM Series - 828 Control Operations; Accessing Machine Parameters; Accessing Software Version; Reverting to Factory Password

22
4.0 828 CONTROL
4.1 ACCESSING MACHINE PARAMETERS
PROCEDURE TO BE PERFORMED BY QUALIFIED PERSONNEL ONLY
1. Press MENU SELECT
2. Select SETUP
3. Select MACHINE DATA
4. Available folders: GENERAL MD / CHANNEL MD / AXIS MD
4.2 ACCESSING THE SOFTWARE VERSION
To find out the version of the software you are running on your 828 control:
1. Press MENU SELECT
2. Select DIAGNOSIS
3. Select VERSION
4. The Software Version number is on the first line and will read: “V##.## + SP ## + HF ##”
4.3 REVERT TO THE FACTORY SET PASSWORD
PROCEDURE TO BE PERFORMED BY QUALIFIED PERSONNEL ONLY
1. Press MENU SELECT
2. Select SETUP
3. Select SET PASSWORD
4. Enter the password: SUNRISE
5. Press OK
6. The lower part of the screen should now read “Current Access Level: Manufacturer”