15
• If it is required for the spindle to run at maximum RPM, the spindle must not run more than 2 hours
straight. After 2 hours of run time at maximum RPM, the spindle must be slowed down to 50% of the
maximum RPM for at least 30 minutes before running at the maximum RPM again.
3.26 Flood Coolant System (Optional)
The flood coolant system consists of a submersible flood pump mounted in the base casting of the machine. The flood
line runs up the back of the column and through the Z-axis cable track. It splits at a y-fitting in the headstock where it
runs to two separate lengths of loc-line.
• The submersible flood pump is mounted behind the access panel shown below.
• The sump can be drained for coolant changes by using a wet vaccum.
To Next Page
Loading...