FUEL MASTER AIM 2 - Figure 2-4. AIM2 Vehicle Components; Figure 2-5. OBD II Pass-Thru Cable

20
RFID Extension Cable
AIM2™ Module
Filler Neck Ring
RFID Interface Module
Figure 2-4. AIM2™ Vehicle Components
Figure 2-5. OBD II Pass-Thru Cable
A chronometer need not be a physical device added to the vehicle/equipment to attain the desired
information. A chronometer input may be as simple as a power source which is only powered
under special circumstances. Engine runtime may be a power source which is only supplying
power when the engine is running; PTO (power takeoff) engage time may be a power source
which is only supplying power when the PTO is engaged. Chronometer inputs may be from as
many as three different sources: through the OBD connection and up to two analog chronometer
inputs, to record vehicle run and idle time, and PTO time.
Cables are available for combining two separate fuel tanks and their filler neck rings into one
AIM2™ module. When this is done, fillups to either tank are recorded. When the transactions are
downloaded into the software, the vehicle record has only one tank record so transactions from