44
CURRENT SIGNATURE = 1234
NEW SIGNATURE (XXXX hex –or- #99999 dec) = 4321
SITE SIGNATURE SET TO: 4321
SAVING SYSTEM CONFIGURATION…
CONFIGURATION RECORDED.
2. Use command 59 to change the system type, as required:
a. When the 59 command is sent to the FMU, the following display appears:
CURRENT SYSTEM OPTIONS (MENU 1) CONFIGURATION
---------------------------------------------
A. SYSTEM INPUT TYPE : VMN - VEH. KEY
B. CUSTOM SYSTEM OPTION : DISABLED
C. ENTERED VEHICLE IDs ARE : NUMERIC
D. SEMI MANUAL MODE : DISABLED
E. REAL GATE TXN : DISABLED
F. POWER FAIL CHECK : NOT AVLAILABLE
G. ENTERED USER IDs ARE : NUMERIC
H. FURNACE LOGGING : DISABLED
I. USING OLD PROKEES : DISABLED
J. SHOW PROKEE/SMARTCARD ID : DISABLED
K. CONFIRM PROKEE/SMARTCARD ID : DISABLED
L. DISPLAY PUMP PRICING : DISABLED
M. EIU PROKEE/SMARTCARD WHICH KEYS : VEH & USER KEY
N. TWO RELAYS PER PUMP : DISABLED
O. AUTO ACTIVATE SINGLE PUMP : DISABLED
P. MODEM CONNECT UPPER SPEED LIMIT : MAXIMUM
USAGE - <LETTER>=CHANGE VALUE, <ESC>=EXIT
b. Option A shows the system type. If the system type is not correct, depress A until the correct
system type appears.
c. When the correct system type is displayed, press Esc. The new system type will be
recorded and the following will be displayed:
CONFIGURATION HAS CHANGED!
WOULD YOU LIKE TO SAVE IT ? (Y/N)
d. If the new system type is correct, depress Y to save it. The following will be displayed:
SAVING SYSTEM CONFIGURATION…
CONFIGURATION RECORDED.
3. Perform “Convert an FMU-3500 into an FMU-3500 Programmer” to configure the FMU
demonstrator unit as a Programmer.
Create an AIM2™ Programmer Prokee
®
/Smartcard
AIM2™ programming through an FMU-3500 is initiated using either a Supervisor
Prokee
®
/Smartcard, or an AIM2™ Programmer Prokee
®
/Smartcard. An AIM2™ Programmer
Prokee
®
/Smartcard may not be used for functions other than programming AIM2™. It cannot be
used to authorize fuel transactions, or to reconfigure an FMU, or most other taskings a
Supervisor Prokee
®
/Smartcard can accomplish. AIM2™ Programmer Prokee/Smartcards are
assigned to individuals identified in the AIM2 Programmer List.
Create an AIM2™ Programmer Prokee®/Smartcard:
To Next Page
Loading...