FUEL MASTER AIM 2 - Clean the AIM2

53
NOTE
Some older versions of FMU firmware may show RESET instead of CLEAN in the following
display.
VID: 1001555 [-MAIN MENU-] (PHT A)
1=CALIBRATE 2=INTERFACE 3=CLEAN D=EXIT
6. To change the interface (OBD or SPEED SENSOR), depress 2=INTERFACE. The following
will be displayed (example shows OBD, could show SPEED SENSOR instead):
VID: 1001555 [-INTERFACE-] (PHT A)
COMMUNICATING WITH AIM…
changing to:
VID: 1001555 [-INTERFACE-] (PHT A)
OBD: CHANGE INTERFACE (Y/N)?
7. Depress the Yes key. A prompt requests the selection of the desired interface:
VID: 1001555 [-INTERFACE-] (PHT A)
SELECT INTERFACE: 1=SPEED SENSOR, 2=OBD
8. Depress 1 or 2 to select the desired interface (1=SPEED SENSOR shown):
VID: 1001555 [-INTERFACE-] (PHT A)
SET AIM TO USE SPEED SENSOR (Y/N)?
9. Depress the Yes key to set AIM2™ to use SPEED SENSOR. The interface is changed:
VID: 1001555 [-INTERFACE-] (PHT A)
SETTING AIM VEHICLE INTERFACE…
10. The interface is changed. As required, depress D=EXIT to exit the FMU.
Clean the AIM2™: if an AIM2™ is removed from one vehicle for installation in another, the
module should be “cleaned” to ensure proper programming and operation in the new vehicle. This is
the only procedure through conventional means which will remove one protocol and recognize
another. “Cleaning” an AIM2™ will change the interface to NONE. When reinstalled in a different
vehicle, the interface must be detected before it can be programmed. Step 8 provides instruction for
resetting the interface to match the new vehicle. As with other FMU AIM2™ options, access to the
MAIN MENU is only possible by first reprogramming the AIM2™ module.
NOTE
AIM2™ programming may be initiated with a Supervisor Prokee
®
/Smartcard or an AIM2™
Programmer Prokee
®
/Smartcard. The following instructions begin using a Supervisor
Prokee
®
/Smartcard. Procedures when using an AIM2™ Programmer Prokee
®
/Smartcard begin with
the display shown in step 3.
1. Insert a Supervisor Prokee
®
/Smartcard. The following will be displayed:
* SUPV: 1=SYSTEM, 2=PM, 3=ODOM, 4=AIM *
* A=CONFIG, B=ISSUES, C=TANKS, D=EXIT *
2. Depress 4=AIM. The following will be displayed: