51
• If a specific chronometer value is not known when calibrating, enter 0 (zero) for the
chronometer value and continue.
VID: 1001555 [-CALIBRATE-] (PHT A)
1=ODOMETER 2=RUN TIME 3=IDLETIME D=EXIT
12. Depress 2=RUN TIME to calibrate engine run time. A prompt will be displayed to confirm
recalibration of engine run time:
VID: 1001555 RUN TIME: 000000 (PHT A)
RECALIBRATE RUN TIME (Y/N)?
13. Depress the Yes key to recalibrate engine run time. A prompt will appear for the input of the
current vehicle hour meter:
VID: 1001555 RUN TIME: 000000 (PHT A)
CURRENT RUN TIME -> ________
NOTE
In step 13, if the current engine run time is not available, enter zero.
14. Enter the current engine run time and press Enter. AIM2™ will recalibrate based on the new
engine run time entry:
VID: 1001555 RUN TIME: 000000 (PHT A)
CURRENT RUN TIME -> 222___
changing to:
VID: 1001555 RUN TIME: 000222 (PHT A)
*** RUN TIME RECALIBRATION COMPLETE ***
NOTE
Some older versions of FMU firmware may show RESET instead of CLEAN in the following
display.
VID: 1001555 [-MAIN MENU-] (PHT A)
1=CALIBRATE 2=INTERFACE 3=CLEAN D=EXIT
15. As required, depress D=EXIT to exit the FMU.
Change the AIM2™ Interface: interface options are NONE, OBD, and SPEED SENSOR.
When an AIM2™ is “cleaned”, the interface is set to NONE. The module cannot be programmed
when the interface is NONE. Modules should detect the correct interface when installed in a vehicle
and powered through the ignition switch. If it is necessary to change the interface through the FMU,
perform the following (access to the MAIN MENU is only possible by first reprogramming the AIM2™
module):
NOTE
AIM2™ programming may be initiated with a Supervisor Prokee
®
/Smartcard or an AIM2™
Programmer Prokee
®
/Smartcard. The following instructions begin using a Supervisor
Prokee
®
/Smartcard. Procedures when using an AIM2™ Programmer Prokee
®
/Smartcard begin with
the display shown in step 3.
1. Insert a Supervisor Prokee
®
/Smartcard. The following will be displayed:
To Next Page
Loading...